RFSAI-61B-SL | Dual Band wireless switching component input button
A switching component with 2 relay outputs is used to control appliances and lights. Internal terminals can connect two existing buttons in the wiring.
They can be combined with detectors, controllers, iNELS RF Control or system components...
The BOX design lets you mount it right in an installation box, a ceiling or a controlled appliance cover.
It allows the connection of switched loads with a total sum of 8 A (2,000 W).
Function: button, impulse relay, and time function of a delayed start or return with time setting range of 2s-60min. It is possible to assign any function to each output relay.
The external button is programmed as a wireless button.
Each output can be controlled by up to 12/12 channels (1 channel represents 1 button on the controller).
The programming button on the unit is also used for manual control of the output.
Memory status can be pre-set in the event of a power failure.
For components labelled as iNELS RF Control2 (RFIO2), it is possible to set the repeater function via the RFAF/USB service device.
Range up to 200 m (in open space), if the signal is insufficient between the controller and unit, use the signal repeater RFRP-20 or protocol component RFIO2 that support this feature.
Communication frequency with bidirectional protocol iNELS RF Control (RFIO2).
TECHNICAL PARAMETERS
Output: 2x switching, 8 A
Supply voltage (frequency): AC 230 V (50-60 Hz)
Design: BOX
Dimensions: 43 x 44 x 22 mm
Protocol: RFIO2